Owner`s manual

2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)

away from the HomeLink威 button you wish to pro-

gram while keeping the HomeLink威 indicator light in

view.

3. Simultaneously press and hold both the HomeLink威

button you want to program and the hand-held trans-

mitter button.

4. Continue to hold both buttons and observe the indi-

cator light. HomeLink威 indicator will flash slowly and

then rapidly after HomeLink威 has received the fre-

quency signal from the hand-held transmitter. Release

both buttons after the indicator light changes from

slow to rapid.

5. Press and hold the programmed HomeLink威 button

and observe the indicator light.

• If the indicator light stays on constantly, program-

ming is complete and the garage door/device should

activate when the HomeLink威 button is pressed.

• To program the remaining two HomeLink威 buttons,

repeat each step for each remaining button. DO NOT

erase the channels.

Reprogramming A Single HomeLink威 Button

To reprogram a channel that has been previously trained,

follow these steps:

1. Cycle the ignition to the ON/RUN position.

2. Press and hold the desired HomeLink威 button until

the indicator light begins to flash after 20 seconds. Do

not release the button.

3. Without releasing the button proceed with “Program-

ming A Non-Rolling Code” Step 2 and follow all

remaining steps.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 137