Owner`s manual

Backup Lamps
1. Reach behind the rear bumper and press the release
tabs on the backup lamp housing.
2. Separate the backup lamp housing from the rear
bumper fascia.
3. Disconnect the electrical harness connector.
4. Turn the bulb and socket assembly counterclockwise,
and then pull it out of the backup lamp assembly.
5. Remove the bulb from the connector socket and install
the replacement bulb.
6. Reinstall the bulb and socket assembly into the backup
lamp assembly, and then turn it clockwise.
7. Reinstall the backup lamp housing into the rear bum-
per fascia.
320 MAINTAINING YOUR VEHICLE