Owner`s manual

Key Fob Programmable Features
The following features may also be programmed by using the Key Fob transmitter or the
ignition switch and driver's door lock switch.
NOTE:
Pressing the LOCK button while you are inside the vehicle will activate the Vehicle
Security Alarm. Opening a door with the Vehicle Security Alarm activated will cause the
alarm to sound. Press the UNLOCK button to deactivate the V ehicle Security Alarm.
Unlock On First Press
To unlock either the driver's side, or all doors, on the first press of the UNLOCK button:
Press and hold the LOCK button for at least four seconds, but no longer than 10
seconds. Then, press and hold the UNLOCK button while still holding the LOCK
button.
Release both buttons at the same time.
Auto Unlock Doors On Exit
To have all of the vehicle doors unlock when any door is opened:
Enter your vehicle and close all the doors, and fasten your seat belt.
Cycle the ignition switch between the LOCK and ON position four times, ending in
the LOCK position (do not start the engine).
Press the power door UNLOCK switch to unlock the doors. A single chime will
indicate that programming is complete.
Sound Horn With Lock
To turn the horn chirp on or off when the doors are locked:
Press the LOCK button for at least four seconds, but no longer than 10 seconds.
Then, press the PANIC button while still holding the LOCK button.
Release both buttons at the same time.
Flashing Lights With Lock
The turn signal lights flashing, when the doors are locked or unlocked, feature can be
turned on or off. To turn this feature on or off:
Press and hold the UNLOCK button for at least four seconds, but no longer than 10
seconds. Then, press and hold the LOCK button while still holding the UNLOCK
button.
Release both buttons at the same time.
ELECTRONICS
90