Installation guide

Operation guide
How to operate Motion detection recording
SENSOR SETUP
SENSOR RECORD TIME 15
ALARM OUT TIME 20
CHANNEL-1 TYPE:MOTION + N-C
CHANNEL-2 TYPE:MOTION + N-O
CHANNEL-3 TYPE:NORMAL
CLOSE
CHANNEL-4 TYPE:NOT
INSTALLED
PRESS (¿À), THEN ( )
PRESS() TO EXIT
PROGRAMMED RECORD
+ T T T S S T T T T T T T T T +
0 3 6 9 12 15 18 21 24
PRESS (
¿À), THEN ( )
PRESS() TO EXIT
Follow the steps as below to
activate motion-detection
recording.
1.Please go to “SENSOR
SETUP” menu as the left
figure shown.
2. Select out the motion option.
3. After the selection, please
be back to MAIN MENU and
go to “PROGRAMMED
RECORD” to power on the
alarm setting.
Notice: The setting under
“PROGRAMMED RECORD” is
necessary for starting the
operation of motion detection
recording.
19