User Manual
Table Of Contents
- 1 Introduction
- 1.1 Document scope
- 1.2 Using this documentation
- 1.3 Safety
- 1.4 Product disposal
- 1.5 Approvals and statements
- 2 GW1000M Series router hardware
- 2.1 GW1000M Series router hardware model features
- 2.2 GW1000M Series router dimensions
- 2.3 GSM technology
- 2.4 WiFi technology
- 2.5 Power supply
- 2.6 Compliance
- 2.7 Operating temperature range
- 2.8 Antenna
- 2.9 GW1000M Series components
- 2.10 Inserting a SIM card
- 2.11 Connecting the SIM lock
- 2.12 Connecting cables
- 2.13 Connecting the antenna
- 2.14 Installing the GW1000M
- 2.15 Installing the GW1000M on a wall
- 2.16 Powering up
- 2.17 Reset button
- Figure 2: GW1000M Series router back
- Figure 1: GW1000M Series router front
- Figure 4: GW1000M Series router back
- Figure 3: GW1000M Series router front
- 3 GW1000M Series LED behaviour
2: GW1000M Series router hardware
_______________________________________________________________________________________________________
2.10 Inserting a SIM card
1. Ensure the unit is powered off.
2. Hold the SIM 1 card with the chip side facing down and the cut corner front left.
3. Gently push the SIM card into SIM slot 1 until it clicks in.
4. If using SIM 2 then hold the SIM with the cut corner front right
5. Gently push the SIM card into SIM slot 2 until it clicks in.
2.11 Connecting the SIM lock
Connect the SIM lock using the Allen key provided.
2.12 Connecting cables
Connect one end of the Ethernet cable into port A and the other end to your PC or
switch. For information on connecting cables for a vehicle installation, read chapter 4,
‘Installing a router into a vehicle’.
2.13 Connecting the antenna
If you are connecting only one antenna, screw the antenna into the MAIN SMA
connector.
If you are using two antennas, screw the main antenna into the MAIN SMA connector
and the secondary antenna into the AUX SMA connector.
2.14 Installing the GW1000M
You can install the GW1000M in a vehicle or on a wall. To read how to install the
GW1000M in a vehicle read the Chapter ‘Installing the router in a vehicle’.
2.15 Installing the GW1000M on a wall
You can mount the router on a wall using the supplied carrier and suitable mounting
fixtures for the wall type (not supplied). You must not mount it more than 2 metres
above floor level.
2.16 Powering up
The router takes approximately 2 minutes to boot up. During this time, the PWR/CONFIG
LED flashes in a double flash pattern – 2 quick fashes followed by a pause.
Other LEDs display different diagnostic patterns during boot up.
Booting is complete when the PWR/CONFIG LED stops double flashing and stays solid or
flashing steady, indicating the particular running configuration is loaded. Read the
chapter ‘GW1000 LED behaviour’, for PWR/CONFIG LED states.
_______________________________________________________________________________________________________
© Virtual Access 2023
GW1000M Series User Manual
Issue: 2.7 Page 20 of 23