User Manual

3: GW1000M Series LED behaviour
_______________________________________________________________________________________________________
3 GW1000M Series LED behaviour
3.1 Main LED behaviour
There are five LEDs on the GW1000M Series router
Figure 5: LEDs on the GW1000M Series router
The possible LED states are:
• Off
• Flashing slowing (2 flashes per second)
• Flashing quickly (5 flashes per second)
• Double flash (2 quick flashes then a pause)
• On
The following table describes the possible LED behaviours and meanings on the
GW1000M Series router.
Booting
The router takes approximately 2 minutes to boot up. During this time,
the power LED flashes.
Other LEDs display different diagnostic patterns during boot up.
Booting is complete when the power LED stops flashing and stays on
steady.
PWR/CONFIG
LED
Off No power/boot loader does not exist.
Double flash Unit is booting from power on.
Flashing slowly Unit is in recovery mode.
Flashing quickly
Unit is in factory configuration.
Solid on Unit has completed booting up process and is in either config 1 or
config2.
SIM LEDs
Off Not selected or SIM not inserted.
Flashing
SIM selected and data connection is being established.
Solid on SIM selected and registered on the network.
Signal LEDs
Both LEDs off Not connected or signal strength <= -113dBm.
Left LED on
Right LED off
Connected and signal strength <= -89dBm.
Left LED off
Right LED on
Connected and signal strength between -89dBm and -69dBm.
Both LEDs on Connected and signal strength >-69dBm.
WiFi LEDs
Off WiFi not enabled.
Flashing Data activity on WiFi interface.
Solid on
WiFi is enabled.
Table 5: LED behaviour and descriptions
_______________________________________________________________________________________________________
© Virtual Access 2023
GW1000M Series User Manual
Issue: 2.7 Page 22 of 23