Owner`s manual

CD Operation
1. Insert/Eject CD
Insert a disc into CD slot with label side
up. The disc will be automatically loaded
into the unit, even when it is off or in radio
mode. The word “LOAD” will blink on the
display and the CD will play automatically.
Press the “EJECT” Button to eject the disc
from the slot. If the disc is not removed
from the slot within 5 seconds, it will
automatically be loaded into the slot again.
When the disc is ejected and removed,
the unit will automatically switch to radio
mode.
2. Multi-Session CD Reading
This unit can read multi-session CDs. The
multi-session reading will be activated
automatically if the player detects a file that
is written in multi-session format. Press and
hold the Volume knob on the faceplate or
the “SEL” button on the remote until "DSP
OFF" is shown on the LCD. Then press the
Volume knob on the faceplate or the “SEL”
button on the remote to cycle through the
menu selections until "MULT OFF" is
shown. Use the VOL +/ - Buttons on the
faceplate or remote to choose "MULT ON"
or "MULT OFF". The default is MULT
OFF .
3. Selecting Tracks
On the Head Unit, press the >>| Button to
advance to the next track on the CD. Track
numbers will be shown on the display. Press
and hold >>| to fast forward the track that is
playing, the elapsed time on the faceplate will
indicate where you are on the track.
Press the |<< Button to go to a previous track.
Track numbers will be shown on the display.
Press and hold the |<< Button to fast reverse.
Disc will play normally when the >>| or |<<
Button is released. On the Remote Control, use
the |<< or >>| Buttons.
4. Play/ Pause CD
On the Remote or Head Unit, press the No.1/
PAU Button to pause the CD. Press this button
again to resume playback.
5. Scanning Tracks
On the Remote or Head Unit, press the
No.2/INT Button to play the first 10 sec-
onds of each track. Press this button again
to resume playback.
6. Repeat
On the Remote or Head Unit, press the
No.3/RPT Button to repeat the same track
continuously. “RPT ON" will appear on
the display. Press this button again to stop
repeating.
7. Random
On the Remote or Head Unit, press the
No.4/RDM Button to play all the tracks in
random order. “RDM ON” will appear on
the display. Press this button again to stop
random play.
Electronic Skip Protection - 12 or 45 seconds .
Press the Volume knob on the faceplate or
the SEL button on the remote for 2 seconds.
The display will show “DSP OFF”. Press
the Volume knob or the SEL button twice
and “ESP12” will be displayed indicat-
ing that Electric Skip Protection will be
activated for 12 seconds. With “ESP 12”
on the display, use the VOL +/- Button to
change the setting to “ESP 45”, indicat-
ing that Electronic Skip Protection for 45
seconds is activated. Leave the unit idle for
the new setting to take effect. The default
is ESP 12. ESP 45 will be displayed in the
center of the LCD.
13