Users Manual Part 1

XVII. Notice for Waste Recycling
, , If this Product is no longer needed or reaches its service life shall be
submitted to the qualified recycling pants recognized by state in accordance
with the relevant laws and regulations for recycling of waste electric pro-
ducts in order to care and protect our earth .
XVI. Faults and Troubleshooting
No picture
No power
Check if AC power wire of this Product is well inserted into power socket.
However, if it still has no power, unplug the power plug and wait for 60s
before reinsert it, then start the machine.
Check the connection of antenna at rear side of machine and try other
channels.
Poor receiving quality
Ghost or illusion may occur if there are high buildings or mountains nearby
and in such case, you may manually adjust the picture quality:please refer
to introduction in “manual searching” or change the receiving direction of
external antenna. If indoor antenna is used,it may have difficult receiving in
some cases. The picture quality can be improved by changing the antenna
direction. However,if poor picture quality still exists, please use an outdoor
antenna.
Clear picture but no ,
sound
Increase volume,check if the machine is mute and press Mute button on remote
controller to cancel mute.
Good sound, but poor
color
Increase contrast and brightness.
Snowflake in picture
and noise
Check connection of antenna at rear side.
Ghost or illusion” “ ,
no response of
remote controller
It may be caused by poor antenna position.Picture quality can be improved
by using high directional antenna;the remote controller should correspond
to remote control sensor on the machine.
If there’s no reaction,check if the plastic isolation paper is removed and
if batteries are correctly installed, and replace the batteries.
If this machine fails to receive signal within min it will be 15 auto-matically
switched to pause state.
Screen is too bright
( )or dark PC mode
Adjust contrast and brightness in main menu .
~ ~23
LCD Touch AIO