Users Manual Part 1

~17~~6~
5.8 Please firstly unplug the power plug of
;motor before cleaning or maintenance other-
wise, an electric shock may occur. Please
clean the screen using soft clothes to avoid
scratching it (see maintenance chapter).
5.9 Never cut, twist, bundle , transform or
bend the conduct,or pull it with much force
during operation, or put anything heavy on
power wire;otherwise,fire hazard and elec-
tric chock may occur due to damage of power
wire.If power wire is damaged, please con-
sult the dealer.
5.4 This Product shall be handled by at least
two persons.It is needed to unplugthe power
wire plug,remove antenna and other devices
before handling . It shall be handled with
caution to avoid impact or screen damage.
5.5 Never stand or sit on this Product. For
family with children,much attention shall be
attached to from climb-preventing children
ing or playing the to avoid TV
displacement, overturning,
damage or other injuries.
5.6 Never disassemble the rear cover, shell
panel or any other cover to avoid electric
shock due to high-voltage parts inside.Please
consult the dealer for any adjustment or
maintenance.
5.7 Never put this roduct or power wire P
near the heater to keep out a fire hazard,since
the surface of shell or power wire may have
deformation and melting if being heated.
5.10 While unplugging the power plug,make
sure to grasp the plug,instead of pulling the
power wire, since it may damage the power
wire and cause a fire hazard
or electric shock.
1. Daily maintenance of touch screen
1) Gently wipe off the dust on surface using
buckskin or high-grade glass cloth.
2) Fingerprint on touch screen of AIO shall
be cleaned using specific detergent for LCD
electronic whiteboard screen.While clean-
ing this Product using detergent,please wipe
it from the center to the surroundings until
the detergent is fully cleaned.
3) In no way should water flow into the in-
terface between electric whiteboard screen
and framework to a void burning the display
due to short circuit.
4) Never wipe the electric whiteboard screen
using hard towel to avoid affecting the dis-
play effects due to fluffing.
5) Stubborn oil dirt may be removed by
pasting transparent tape on screen and then
removing it.
5.11 N ever place this roduct in a shocking, P
tilted or unstable place;otherwise, this ro-P
duct may be falling or overturned and thus
leading to an injury or damage.
5.12 If this Product is to be long idled if you
are in travelling or business trip, please un-
plug the power plug to keep out a fire hazard
due to degraded insulation performance of
power wire.
VI. Introduction to Product
Operation and Maintenance
LCD Touch AIOLCD Touch AIO
: Open the saved.donv file,tapped to pop up the file selection window (showing
all the Android directories by default),where the user can tap the “default path”
to go directly to the the Board install path, or select the USB path, or
other local Android path, as shown below.
: current Save current page as .png picture, automatically name after the machine’s
time, and the picture can be viewed in the gallery.
: Save all pages as .donv file, tapped to pop up the file saving window (showing
all the Android directories by default),where the files are automatically named
after the machine’s current time,and the user can tap the “default path” to go
directly to the path to install the Board, or select the USB path, or other
local Android path, as shown below.
Note: Uninstalling and reinstalling the WhiteBoard software will automatically
delete all files in the installation directory. If the files are saved in the default path,
uninstalling and reinstalling the software will delete the previously saved files. If you
don’t want the files to be deleted, you can choose to save them in the other local Android path.