User`s manual

13. ASSIGNING MIDI CONTINUOUS CONTROLLERS
It is possible to assign Continuous Controller numbers between 1 and 120 to the following parameters:
SHORT NAME PARAMETER DEFAULT CC
BYPASS Stereo BYPASS 102
RUN/STOP Rotary Speed RUN or STOP N/A
SLOW/FAST Rotary Speed SLOW or FAST N/A
OVD SW Tube Overdrive Toggle 103
OVD GAIN Tube Overdrive Gain 111
OVD LEVEL Tube Overdrive Level 112
PARAM 1 Parameter 1 91
PARAM 2 Parameter 2 93
PARAM 3 Parameter 3 N/A
Assigning a CC is very easy: press EDIT/ENTER to choose the parameter to which to assign the CC. While browsing the
parameter list, automatically the assigned CC number is shown. If no CC is assigned to a parameter, the dash symbol "-"
is shown; if the default CC number is assigned to a parameter, the letter D is shown after the number.
[MIDI] CC ASSIGN
OVD LEVEL > 109
Press again EDIT/ENTER to choose the CC number and rotate the encoder to select a number between 1 and 120. If a
MIDI device is connected to the BURN and sends Continuous Controller messages, the CC number shown on the display
is automatically updated with the last received CC number. To confirm the assignment, push EDIT/ENTER once again. To
cancel an assignment, for example in order to avoid conflicts with other MIDI devices in the chain, rotate the encoder
fully counterclockwise until a dash symbol "-" is shown and confirm by pushing EDIT/ENTER.
14. MAPPING MIDI PROGRAM CHANGE VS. PRESETS
The BURN has 32 presets but the total number of Program Change numbers in the General MIDI system is 128, ranging
0 to 127. It is, therefore, possible to choose a PC number per each preset via the [MIDI] PC MAP page.
[MIDI] PC MAP
Preset:12 PC:114
Press EDIT/ENTER and rotate the encoder to choose a preset number between 0 and 31. Press EDIT/ENTER again to
shift to the next value and rotate the encoder choose a PC number to assign to the preset. By default, presets 0 to 31 are
assigned to the same Program Change numbers. If a PC number is assigned to more tha one preset, only the preset with
the lower PC number will be recalled.
It is possible to exclude the received Continuous Controller or Program Change messages in the case it is preferrable to
avoid that these would interfere with other devices in the MIDI chain. Go to the page [MIDI] CC RECV or [MIDI] PC RECV
and set the related function as Enabled or Disabled according to your preference.
[MIDI] CC RECV
Enabled
GSi BURN USER'S MANUAL - Pag. 12/16