Datasheet

System 6000
Vishay Micro-Measurements
StrainSmart
®
Data Acquisition System
Document Number: 11270 [e-mail] www.vishaymg.com
Revision 14-Nov-06 45
MODEL 6095 DIGITAL/TACHOMETER CARD
• Multi-function digital input card
• Relay output for control functions
• Compatible with all System 6000 hardware
• Supported by StrainSmart software
When used in conjunction with Vishay Micro-Measurements
StrainSmart
®
Software, the Model 6095 Digital/Tachometer
Card enables the user to capture and reduce data in any one
of five operating modes:
• Tachometer Mode
• Interval Mode
• Quadrature Mode
• Counter Mode
• Digital Input Mode
Depending upon the mode selected, data can be reduced as
a digital input; counts; interval counts; pulses; rate; shaft
angle; RPM; radians or degrees per second; elapsed time
(milliseconds, seconds or minutes); or calculated values.
Multiple Model 6095 Cards can be used in each system, and
each card in a system can be configured individually to any
operating mode. However, the relay provides one distinct
control function (on/off control for testing machines, etc.) per
system when using a Model 6100 Scanner, or one per
scanner when using multiple Model 6200 Scanners.
The Model 6095 is compatible with all Model 6100 and 6200
Scanners. It is supported by Version 3.0, and later,
StrainSmart Software; no-charge upgrades are available
upon request.
INPUT CONNECTOR: Nine-pin, D-sub style
RELAY OUTPUTS:
Quantity: One
Configuration: NO and NC, 500mA contact at 30Vac or
30Vdc into resistive load.
DIGITAL INPUTS:
Quantity: Four
Configuration: Optically isolated. TTL Schmitt-trigger
input thresholds accept up to 28Vdc without damage.
2.23Ω pull-up resistors can be selected for each input.
Impedance: 50kΩ
Data Rate: DC to 200kHz
Accessory Supply: 5 Volt ± 5%, 75mA