Datasheet

UIPMA, UIPMC
www.vishay.com
Vishay MCB
Revision: 04-Feb-2019
3
Document Number: 32537
For technical questions, contact: [e-mail]
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
MOUNTING REQUIREMENTS FOR UIPMA
1. The shape of the customer interface over the active area shall be:
2. The roughness of the customer interface over the active area shall be:
3. Before sticking the sensor, the interface surface shall be free of all traces of dirt, grease, foreign objects, and burrs.
4. The bending of the flat flex cable shall be: Ø 3 mm min.
ELECTRICAL DIAGRAM
The voltage varies according to the position of the presser
on the deformable membrane.
SPECIFIC VERSIONS (on request)
• Other electrical or mechanical characteristics
• Other bases
• Integration in equipment
• Other versions: outdoor design, ...
• Integration in equipment
(flat flex cable, contacts, wires, ...)
DIMENSIONS in millimeters
UIPMC
0.05
Ra 1.6
Active side
Back
TET
UET
Ø 12 (centering diameter)
Ø 18
Ø 24
Ø 30
25
R5 (x 2)
10
Adhesive area
Thickness 0.51 ± 0.1 without removal of protection layer
Pin 1
Pin 2
Pin 3
Pin 1 V+
Pin 2 Collector
Pin 3
GND
15
Connector:
Duex HSNG SR1 100-2P3S
(Ref: 67013-003LF or alternative)
Duex contact female
(Ref: 76785-301LF or alternative)
F
Yellow
Red
Green