Datasheet

Document Number: 28766 For technical questions, contact: [e-mail]
www.vishay.com
Revision: 28-Aug-07 29
MBA/SMA 0204, MBB/SMA 0207, MBE/SMA 0414 - Professional
Professional Leaded Resistors
Vishay Beyschlag
TESTS AND REQUIREMENTS
Essentially all tests are carried out in accordance with the
following specifications:
EN 140000/IEC 60115-1, Generic specification (includes
tests)
EN 140100/IEC 60115-2, Sectional specification (includes
schedule for qualification approval)
CECC 40101-806, Detail specification (includes schedule for
conformance inspection)
Most of the components are approved in accordance with the
European CECC-system, where applicable. The Test and
Requirements table contains only the most important tests.
For the full test schedule refer to the documents listed above.
The testing also covers most of the requirements specified
by EIA/IS-703 and JIS-C-5202.
The tests are carried out in accordance with IEC 60068 and
under standard atmospheric conditions in accordance with
IEC 60068-1, 5.3. Climatic category LCT/UCT/56 (rated
temperature range: Lower Category Temperature, Upper
Category Temperature; damp heat, long term, 56 days) is
valid.
Unless otherwise specified the following values apply:
Temperature: 15 °C to 35 °C
Relative humidity: 45 % to 75 %
Air pressure: 86 kPa to 106 kPa (860 mbar to 1060 mbar).
For testing the components are mounted on a test board in
accordance with IEC 60115-1, 4.31 unless otherwise
specified.
In Test and Requirements Table, only the tests and
requirements are listed with reference to the relevant clauses
of IEC 60115-1 and IEC 60068-2; a short description of the
test procedure is also given.
TEST PROCEDURES AND REQUIREMENTS
IEC
60115-1
CLAUSE
IEC
60068-2
TEST
METHOD
TEST PROCEDURE
REQUIREMENTS
PERMISSIBLE CHANGE (ΔR
max
)
stability for product
types:
STABILITY
CLASS 0.5
STABILITY
CLASS 1
STABILITY
CLASS 2
MBA/SMA 0204 1 Ω to 332 kΩ 0.22 Ω to < 1 Ω > 332 kΩ
MBB/SMA 0207 1 Ω to 1 MΩ 0.22 Ω to < 1 Ω > 1 MΩ
MBE/SMA 0414 1 Ω to 2.4 MΩ 0.22 Ω to < 1 Ω > 2.4 MΩ
4.5 - resistance ± 5 %; ± 1 %; ± 0.5 %
4.8.4.2 -
temperature
coefficient
at 20/LCT/20 °C and
20/UCT/20 °C
± 50 ppm/K; ± 25 ppm/K