User's Manual

Product Note
Using the Remote
After connecting the receiver properly, simply start your PowerPoint presentation, put it in SlideShow mode,
and press the larger advance button to advance the slides and the smaller reverse button to go back to the
previous slide. The advance button mimics the “N” (next) button on the keypad and the reverse button mim-
ics the “P” (previous) button. Press the smallest button to activate the laser pointer.
Changing the Battery in the Remote
1
There are two “alignment dots” on the back of the remote case and one “alignment dot” on the battery
cover. Insert a quarter into the slot on the battery cover and turn counter clockwise until the dot on the
battery cover is lined up with the LEFT dot on the remote case. The battery cover will release.
2
Pry the battery out of the holder. Dispose of the battery in an environmentally proper manner.
3
Insert the new battery with the positive side facing you. The lithium 3.0 volt battery number is CR2032.
4
Make sure that the “alignment dot” on the battery cover is lined up with the LEFT “alignment dot” on
the remote case as you replace the battery cover. Then turn clockwise until the dot on the battery cover
is lined up with the RIGHT dot on the remote case.
It is recommended that you always carry a spare battery.
Troubleshooting
“I’m pressing the advance button but the slides are not advancing.”
1
Check the cable connections.
2
Verify that the LED on the remote comes on solid when the advance or reverse button is pushed and
that the laser pointer is at full brightness when the laser button is pushed. If not, replace the battery.
3
Verify that the transmitter has been trained to the receiver.
4
If using USB, verify that the correct operating system driver is loaded on your computer.
5
If using PS/2, try restarting the computer with the receiver plugged into the PS/2 port. Try reloading
the driver, or try unplugging the receiver, waiting 10 seconds, and then plugging it back in.
“The LED on the remote flashes or does not turn on when I push the advance or reverse button, or the laser
pointer is dim or does not work when the laser button is pushed.”
1
The battery is dead. Replace the battery.
“My slides are not advancing, and I see the letters “N” or “P” on the screen.”
1
Make sure that you have your presentation software in slide show mode. Pressing the advance button
on the remote mimics pressing the “N” (next) button on the keypad and pressing the reverse button
mimics pressing the “P” (previous) button while in SlideShow mode of PowerPoint. Other presentation
applications may not interpret “N” and “P” as Next and Previous.
Product Specifications
Transmitter:
· Range: Up to 75 feet, depending upon operating environment
· Dimension: 2.6” (66mm)L x 1.5"(38mm)W x 0.5”(13mm)H
· Weight: 1 oz (24 g) with batteries
· Radio Frequency: 433 MHz
· Laser: Diode Laser, 5mW max output at 650NM, Class IIIa
· Power: CR2032 battery
· Battery life: 1 year under normal operation
Receiver:
· Interface: PS/2 or USB port
· Dimensions: 2.6”(66mm)L x 3.4” (86mm)W x 1.2” (31mm)H
· Weight: 2 oz (59g) excluding cable
RF remote.fm Page 2 Friday, May 4, 2001 10:30 AM