Installation & Operation Manual ZM1601IN-5 ZM1601MY-5 ZM1601EU-5 ZM1601RU-5 ZM1601US-5 ZM1601IL-5 ZM1601KR-5 ZM1601HK-5 ZM1601JP-5 ZM1601BR-5 Wireless Siren & Strobe Alarm Battery Power ZM 1601-5 V0 1031128 6B1Z-16005
COMMAND_CLASS_DEVICE_RESET_LOCALLY COMMAND_CLASS_FIRMWARE_UPDATE_MD_V2 COMMAND_CLASS_MANUFACTURER_SPECIFIC_V2 COMMAND_CLASS_NOTIFICATION_V4 COMMAND_CLASS_POWERLEVEL COMMAND_CLASS_SECURITY COMMAND_CLASS_SWITCH_BINARY (mapping COMMAND_CLASS_BASIC) COMMAND_CLASS_VERSION_V2 COMMAND_CLASS_ZWAVEPLUS_INFO Introduction Thanks for choosing the Vision’s wireless siren & strobe alarm of the home security device.
Note: a. LED setting light will flash continuously in Exclusion condition. b. All user and network settings will be cleared and the device reset to factory defaults when the device is excluded. send notification. Alarm Type Alarm Level For “Association”: removing the back cover of the ZM1601 to get into “Awake” mode, then put the Z-Wave Interface Controller into “association”, and following its instruction to association the ZM1601 with other device.
Federal Communications Commission Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications.
Industry Canada Notice Operation is subject to the following two conditions: (1) this device may not cause interference and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Industry Canada Caution This device complies with Industry Canada licence-exempt RSS standard(s).
