User's Manual

ManualsBrandsVision Automobile Electronics Industrial ManualsElectronicsWireless PIR Motion Sensor

Installation & Operation Manual

ZP3102IN-5

ZP3102MY-5

ZP3102EU-5

ZP3102RU-5

ZP3102US-5

ZP3102IL-5

ZP3102KR-5

ZP3102HK-5

ZP3102JP-5

ZP3102BR-5

Wireless PIR Motion Sensor

(Temperature Sensor Built-In)

ZP 3102-5

1031125

6B1Z-31002

Summary of content (5 pages)

PAGE 1
Installation & Operation Manual ZP3102IN-5 ZP3102MY-5 ZP3102EU-5 ZP3102RU-5 ZP3102US-5 ZP3102IL-5 ZP3102KR-5 ZP3102HK-5 ZP3102JP-5 ZP3102BR-5 ZP 3102-5 V1 1031125 6B1Z-31002 Wireless PIR Motion Sensor (Temperature Sensor Built-In)
PAGE 2
Z-Wave Command Classes: Introduction COMMAND_CLASS_ASSOCIATION_GRP_INFO COMMAND_CLASS_ASSOCIATION_V2 COMMAND_CLASS_BASIC COMMAND_CLASS_BATTERY COMMAND_CLASS_CONFIGURATION COMMAND_CLASS_DEVICE_RESET_LOCALLY COMMAND_CLASS_FIRMWARE_UPDATE_MD_V2 COMMAND_CLASS_MANUFACTURER_SPECIFIC_V2 COMMAND_CLASS_NOTIFICATION_V4 (mapping _COMMAND_CLASS_BASIC) COMMAND_CLASS_POWERLEVEL COMMAND_CLASS_SECURITY COMMAND_CLASS_SENSOR_MULTILEVEL_V5 COMMAND_CLASS_VERSION_V2 COMMAND_CLASS_WAKE_UP_V2 COMMAND_CLASS_ZWAVEPLUS_INFO_V2 Th
PAGE 3
4. Awake Mode: It will be triggering after opening the front cover (refer Table 2), also the red LED will keep on lasting 10 seconds and ZP3102 will send “Wake Up Notification” after 10 seconds. 5. Auto Wake Up: Use “Wake Up” command to set up the awaking time (from 10 minutes to 1 week) and send the wake up notification to controller 6..
PAGE 4
(Movement) Notification V4 Notification Type 0x07 0x07 Notification Event 0x08(Motion Detected)/ 0x00 (no movement after 3 mins) 0x03(remove cover)/ 0x00 (cover closed) Notification Parameter 0x08 0x03 Alarm V1 (Movement & Tamper Switch) Alarm Type Alarm Level Notification V4 (Tamper Switch) 0x07 0x00 (No movement after 3 mins) 0xFF (Motion detected) (Table 2) 6. Support OTA Firmware update from controller. Please refer to your controller manual.
PAGE 5
Industry Canada Notice Operation is subject to the following two conditions: (1) this device may not cause interference and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Industry Canada Caution This device complies with Industry Canada licence-exempt RSS standard(s).