User's Manual

ManualsBrandsVision Automobile Electronics Industrial ManualsElectronicsZ-WAVE PIR SENSOR

Operation

1. Walk in front of ZP3102, sensor will send the status of “ON” (Basic Set,Value:0xFF) to

any associated nodes, and the LED will flash once.

2. If no movement detected, the sensor will send the status of “OFF” (Basic

Set,Value:0x00) to any associated nodes

3. Normal operation, the LED will not light.

4. The ZP3102 sensor equipped with tamper switch. If the cover of sensor is removed,

the PIR sensor will send an alarm report (type:01, level:11) to the Z-Wave™ Interface

Controller, and the LED will go solid. Before replacing the cover, the sensor is uder

“Awake” mode.

Federal Communications Commission Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instruction, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try and correct the interferene by one of the following measures:

- Reorient or relocate the receiving antenna,

- Increase the separation between the equipment and receiver,

- Connect the equipment into and outlet on a circuit different from that to which the

receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undersired

operation.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate this equipment.

Limited Warranty

Vision Guarantees that every wireless PIR sensor is free from physical defects in material

and workmanship under normal use for one year from the date of purchase. If the product

proves defective during this one-year warrany period, Vision will replace it free of charge.

Vision does not issue any refunds. This warnnty is extended to the original end user

purchase only and is not transferable. This warranty does not apply to : (1) damage to units

caused by accident, dropping or abuse in handling, or any negligent use; (2) units which

have been subject to unauthorized repair, taken apart, or otherwise modified; (3) units not

used in accordance with instruction; (4) damanges exceeding the cost of the produt; (5)

transit damage, initial installation costs, removal cost, or reinstallation cost.

For information on addional devices, plesae visit us at www.visionsecurity.com.tw

Installation & Operation Manual

ZP 3102 EU

ZP 3102 US

ZP 3102 AU

Wireless PIR Motion Sensor

ZP 3102 V0 20110216 6B1Z-31001

Summary of content (2 pages)

PAGE 1
Operation 1. 2. 3. 4. Walk in front of ZP3102, sensor will send the status of “ON” (Basic Set,Value:0xFF) to any associated nodes, and the LED will flash once. If no movement detected, the sensor will send the status of “OFF” (Basic Set,Value:0x00) to any associated nodes Normal operation, the LED will not light. The ZP3102 sensor equipped with tamper switch.
PAGE 2
Introduction Thanks for choosing the Vision’s wireless PIR motion sensor of the home security device. TM enabled device (interoperable, two-way RF mesh networking This sensor is a Z-Wave technology) and is fully compatible with any Z-Wave TM enabled network. Every mains TM enabled device acts as a signal repeater and multiple devices result in powered Z-Wave more possible transmission routes which helps eliminate “RF dead-spots”.