User's Manual

Installation & Operation Manual

ZS 6101 IN-5 ZS 6101 EU-5

ZS 6101 RU-5 ZS 6101 US-5

ZS 6101 JP-5 ZS 6101 BR-5

ZS 6101 KR-5 ZS 6101 IL-5

ZS 6101 MY-5 ZS 6101 HK-5

Wireless Smoke Detector

(w/o FLiRs version)

ZS 6102 IN-5 ZS 6102 EU-5

ZS 6102 RU-5 ZS 6102 US-5

ZS 6102 JP-5 ZS 6102 BR-5

ZS 6102 KR-5 ZS 6102 IL-5

ZS 6102 MY-5 ZS6102 HK-5

Wireless Smoke Detector

(support FLiRs version)

ZS 6101-5/ZS6102-5

1030704

6B1Z-61003

PAGE 1
Installation & Operation Manual ZS 6101 IN-5 ZS 6101 EU-5 ZS 6101 RU-5 ZS 6101 US-5 ZS 6101 JP-5 ZS 6101 BR-5 ZS 6101 KR-5 ZS 6101 IL-5 ZS 6101 MY-5 ZS 6101 HK-5 Wireless Smoke Detector (w/o FLiRs version) ZS 6102 IN-5 ZS 6102 EU-5 ZS 6102 RU-5 ZS 6102 US-5 ZS 6102 JP-5 ZS 6102 BR-5 ZS 6102 KR-5 ZS 6102 IL-5 ZS 6102 MY-5 ZS6102 HK-5 Wireless Smoke Detector (support FLiRs version) ZS 6101-5/ZS6102-5 V0 1030704 6B1Z-61003
PAGE 2
Installation Operation Notice: If you are installing the entire Z-Wave™ system for the first time, please refer to the installation guide of Z-Wave™ Interface Controller before installing ZS6101. 1. Remove the bracket from the detector by rotating it counter-clockwise. 2. Place the bracket where you are going to install the detector. In each of key hole slots, draw a mark to locate plastic anchor and screw.
PAGE 3
PowerLevel Control: Using “PowerLevel Set” to set up the RF strength. And using “PowerLevel Test Node Set” to tests the RF signal of specific node. 12. Support “Firmware Update” After firmware update and before using the smoke detector, please exclude the unit from the gateway first and re-include it back. 11.