User's Manual

ManualsBrandsVision Automobile Electronics Industrial ManualsElectronicsZ-Wave Keyfob

Federal Communications Commission Statement

This equipment has been followed to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try and

correct the interferene by one of the following measures:

Reorient or relocate the receiving antenna,

Increase the separation between the equipment and receiver,

Connect the equipment into and outlet on a circuit different from that to which the receiver

is connected.

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undersired

operation.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate this equipment.

Limited Warranty

Vision Guarantees that every keyfob is free from physical defects in material and

workmanship under normal use for one year from the date of purchase. If the product

proves defective during this one-year warranty period, Vision will replace it free of charge.

Vision does not issue any refunds. This warranty is extended to the original end user

purchase only and is not transferable. This warranty does not apply to : (1) damage to

units caused by accident, dropping or abuse in handling, or any negligent use; (2) units

which have been subject to unauthorized repair, taken apart, or otherwise modified; (3)

units not used in accordance with instruction; (4) damages exceeding the cost of the

product; (5) transit damage, initial installation costs, removal cost, or reinstallation cost.

For information on addional devices, plesae visit us at www.visionsecurity.com.tw

Installation & Operation Manual

ZT1101IN-5

ZT1101MY-5

ZT1101EU-5

ZT1101RU-5

ZT1101US-5

ZT1101IL-5

ZT1101HK-5

ZT1101KR-5

ZT1101BR-5

ZT1101JP-5

Keyfob

(w/o AES version)

ZT1101

1040

703

6B1Z

1001

ي

Z-Wave Keyfob

Summary of content (3 pages)

PAGE 1
Federal Communications Commission Statement This equipment has been followed to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications.
PAGE 2
Introduction Thanks for choosing the Keyfob of the home security device. This keyfob is a Z-Wave™ ‫ و‬enabled device (interoperable, two-way RF mesh networking technology) and is fully compatible with any Z-Wave™ enabled network.
PAGE 3
5) Switch All ON/OFF: * Open All: Press button 1 and 2 together until the green LED flash once and the keyfob will send “SWITCH_ALL_ON” command * Close All: Press button 3 and 4 together until the red LED flash once and the keyfob will send “SWITCH_ALL_OFF” command 6) Mode Switch: * Press button 2 and 4 together until green LED flashes to switch to “Central Scene Mode”. * Press button 1 and 3 together until red LED flashes to switch to “Scene Activation Mode”.