Assembly Guide T9250, T9350HRT AND T9450HRT FOLDING TREADMILLS
Assembly Guide T9250, T9350HRT AND T9450HRT FOLDING TREADMILLS To avoid possible damage to this Folding Treadmill, please follow these assembly steps in the correct order. Before proceeding though, find your new Folding Treadmill’s serial number, located on the underside of the main frame, and enter here: Refer to this number when calling for service, and also enter this serial number on your Warranty Card and in your own records. Be sure to read your Owner’s Guide before using your new Folding Treadmill.
TOOLS, HARDWARE, & PARTS INCLUDED 8mm Allen Wrench 5mm Allen Wrench Screwdriver PARTS BOX Water Bottle, Qty: 1 Heart Rate Chest Strap, Qty: 1 (Except T9250) Color-coded Hardware Bags Owner’s Guide Assembly Guide Warranty Card
HARDWARE INCLUDED ORANGE BAG PINK BAG M8 x 20L Bolts Quantity: 2 M8 x 20L Bolts Quantity: 4 M8 x 50L V-Head Bolts Quantity: 2 BLUE BAG M4 x 12L V-head Screw Quantity: 2 M4 x 12L V-head Flat Screw Quantity: 4 M8 x 135L Bolts Quantity: 4
STEP 1 ORANGE BAG • Fold up the right-hand console mast to the vertical position. Be sure not to pinch the data cables. STEP • Insert the bolt (M8 x 50L) in the side and tighten with the blue-handled 5mm Allen Wrench. 1 • Insert one bolt (M8 x 20L) in the front and tighten with the blue-handled 5mm Allen Wrench. • Repeat this on the opposite side. NOTE: There are no data cables on the left side. STEP 2 BLUE BAG • Slide the base side covers down the left-hand and right-hand console masts.
STEP 3 PINK BAG • Mount the right-hand side mount handlebars to the console mast using two bolts (M8 x 135L). Repeat this on the left-hand side. • Plug in the large data cable into the large plug connection in the connection box on the right-hand side of the console. • Plug in the small data cable into the small plug connection in the connection box on the right-hand side of the console NOTE: Push all extra data cable into the console mast. Make sure not to pinch or cut the data cable.
STEP 4 AUTO-CALIBRATION Once the treadmill is plugged in, you need to perform an Auto-Calibration to assure maximum performance. MODELS T9350HRT & T9450HRT: DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION • You need to access User Engineering Mode to run the Auto-Calibration. With the Safety Key in place, please hold down SPEED DOWN and SELECT for 5 seconds. When in the User mode, "USEr" displays in the center window.
STEP 5 BELT TENSION • If the running belt slips when used, use the supplied 8mm Allen wrench to turn the left and right tension bolts clockwise 1/4-turn at a time until the belt no longer slips. STEP • If the running belt is too far to the right side, use the supplied 8mm Allen wrench to turn the right tension bolt clockwise 1/4-turn at a time until the belt remains centered during use.
