Semi-Recumbent & Upright Fitness Bikes Owner's Guide

GENERAL

TROUBLESHOOTING YOUR FITNESS BIKE

Our Bikes are designed to be reliable and easy to use. If, however, you

have a problem, these troubleshooting steps may indicate the cause.

PROBLEM: The Console does not light up.

SOLUTION: 1) Pedal bike to light up console.

SOLUTION: 2) Replace 9 Volt battery in back of console.

PROBLEM: The Bike is making a

clicking noise.

SOLUTION: Using a 15MM

wrench, remove both the right and

left pedals. Apply grease to the

threaded portion of the pedals

and reassemble the unit, making

sure the pedals are as tight as

possible.

PROBLEM: The Bike appears to work, but there is no resistance change.

SOLUTION: The magnetic brake assembly is not working properly; please

contact your retailer.

PROBLEM: The Bike makes a squeaking or creaking noise.

SOLUTION: Check and tighten all the bolts on the Bike again.

PROBLEM: The seat on your

recumbent bike rocks from side to

side.

SOLUTION: With a 13MM

wrench, loosen the Fixing Nuts on

the side of the seat frame. With an

11MM wrench, pivot the

Adjusting Post so the Fixing Nut is

at the top of the slot. Tighten the

Fixing Nut with the 13MM

wrench.

NOTE: If the above steps do not remedy the problem, discontinue use and

contact your retailer.