Assembly Guide T9200, T9300, T9500HRT, AND ALL T9600HRT AND T9700 Series PLATFORM TREADMILLS
Assembly Guide T9200, T9300, T9500HRT, AND ALL T9600HRT AND T9700 Series PLATFORM TREADMILLS To avoid possible damage to this Platform Treadmill, please follow these assembly steps in the correct order. Before proceeding though, find your new Platform Treadmill’s serial number, located on the underside of the main frame, and enter here: Refer to this number when calling for service, and also enter this serial number on your Warranty Card and in your own records.
TOOLS & PARTS INCLUDED 8 MM Allen Wrench 5mm Allen Wrench Screwdriver PARTS BOX Water Bottle, Qty: 1 Heart Rate Chest Strap, Qty: 1 (Except Models T9200 and T9300) Color-coded Hardware Bags Owner’s Guide Assembly Guide Warranty Card
HARDWARE INCLUDED ORANGE BAG BLUE BAG M8 x 15L Bolts Quantity: 4 M8 x 20L Bolts Quantity: 2 M8 x 55L Flathead Bolts Quantity: 4 YELLOW BAG M4 x 12L Panhead Screws Quantity: 4 M8 x 135L Bolts Quantity: 4
STEP 1 ORANGE BAG • Slide the rubber covers on to the left & right console supports, making sure that the lower cutout is facing inward. T9700-Series: Slide the data cable down the right console support using the white wire tie as a guide. Make sure that the data (1 large ribbon cable) goes through the large hole in the lower part of the console upright. STEP T9200, T9300, T9500HRT & T9600HRT Series: Slide the data cables down the right console support using the white wire tie as a guide.
STEP STEP 2 BLUE BAG • Mount the console to the console mast using four bolts (M8 x 15L) and tighten with the 5mm Allen wrench. 2 NOTE: Push all extra data cable into the console mast. Make sure not to pinch or cut the data cable. • Mount the right-hand side mount handlebar to the console mast using two bolts (M8 x 135L). Repeat this on the left-hand side.
STEP 4 AUTO CALIBRATION Once the treadmill is plugged in, you need to perform an Auto Calibration to assure maximum performance. MODELS T9300, T9500HRT, T9600HRT & T9600HRT Comfort: DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION • You need to access User Engineering Mode to run the Auto Calibration. To access this mode, please hold down SPEED DOWN and SELECT for 5 seconds. When in the User mode, "USEr" displays in the center window.
STEP 5 BELT TENSION • If the running belt slips when used, use the supplied 8MM Allen wrench to turn the left and right tension bolts clockwise 1/4-turn at a time until the belt no longer slips. STEP • If the running belt is too far to the right side, use the supplied 8MM Allen wrench to turn the right tension bolt clockwise 1/4-turn at a time until the belt remains centered during use.
