Platform Treadmills Assembly Guide

5
1
STEP
• Slide the rubber covers on to the left
& right console supports, making sure
that the lower cutout is facing inward.
T9700-Series: Slide the data cable
down the right console support using
the white wire tie as a guide. Make
sure that the data (1 large ribbon
cable) goes through the large hole in
the lower part of the console upright.
T9200, T9300, T9500HRT &
T9600HRT Series: Slide the data
cables down the right console support
using the white wire tie as a guide.
Make sure that the data cables (one
small grey & one large black
telephone-style cable) go through the
large hole in the lower part of the
console upright.
• Insert the left console support into
the console support bracket and
secure with two bolts (M8 x 55L
Flathead) in the side of the console
support bracket.
• Insert one bolt (M8 x 20L) in the
rear of the console support bracket.
• Tighten all three bolts with the 5mm
Allen wrench.
• Repeat this on the right side.
NOTE: There are no data cables on
the left side.
ORANGE BAG
1
STEP