Instructions / Assembly

ManualsBrandsVision Grills ManualsGrill AccessoriesQuickchange Natural Gas Insert for S-Series Kamado Grill

Visit

www.visiongrills.com/register

to register your grill and

view frequently asked questions

• Attach the two hose brackets (used to hold

gas hose), with eyelets facing in, onto the

front and rear legs of cart (Step 1).

Note: Do NOT allow the hose to touch

the ceramic.

STEP 1

Watch For Bubbles

*Leak Test:

Pour Leak Test Solution (not included)

or soapy water at the connection spot

of the gas cylinder to check whether

there is gas leakage. If solution produces

bubbles this means there is a leak.

PARTS

Step 1: Attach Hose Brackets

PART NAMES PART NUMBERS

1 Infrared Heat Exchanger

2 Gas Grill Burner Insert

2.1 Gas Grill Burner Insert Knob

2.2 Ignition Button Cap

3 Gas Hose with Quick

Disconnect Fitting

4 Gas Supply Hose Bracket (x2)

5 Lava Stone

6 SS Stone Bracket

VGC GPIHE

VGC GPBI-S

VGC GPBIK

VGC GPIBC

VGC GHQD1

VGC GPGSLC-2

VGK-101R

VGK-BRACKET

• Remove Ignition Button Cap by

turning counter clockwise. Insert

AA battery (not included) negative

end ﬁrst.

• Replace Ignition Button Cap by

tightening clockwise.

• Press Red Ignition Button and hold

in to test battery. This will create

spark on burner for starting (See

manual for starting operation).

WARNING: To avoid shock, do not touch spark on burner

Step 2: Install Battery

STEP 2

–

SET UP

ENGLISH

KAMADO Quickchange Natural Gas Insert

for S-Series

Kamado Grills

Model # VGK-NPAK-S1

Patent Pending

2.1

2.2

• From rear of grill, feed gas hose through

eyelets of the hose brackets, grill

connector ﬁrst. Connect gas hose to the

Gas Insert using the Quick Disconnect

ﬁtting.

• Make sure the gas valve is closed.

• Inspect valve connections, port, hose and regulator assembly for any

damage or debris. Remove any debris.

• After the gas hose is connected to the gas source and Gas

Insert, open valve from gas source and use a leak test to test the

connections.

Step 3: Connect to Gas Source

•

Using the Quick Connect ﬁtting on the Gas Supply

Hose, pull back spring-loaded locking ring and

slide over male connection.

•

Once it has snapped into place, give slight tug on

gas line to ensure that it is securely connected.

•

Turn valve on gas source to Open position.

STEP 3

Lock Top Vent

Turn Cast Iron Top Vent to position 3. Turn locking pin

counter clockwise until it drops down in place, keeping

the Top Vent fully open.

WARNING: When using Quickchange Gas Insert, Top Vent must be

locked open to position 3 at all times.