Installation guide

Page 9 / 16
6. Installation
6-1. Lens
Lens is not supplied with the unit. C-Mount or CS-Mount type of lens is useable.
Please select a lens that has a good F-Stop number in order to get the best picture quality. Use of DC auto iris
lens is recommended to achieve the best results for operating this product effectively.
☞ Caution
Please make sure the surface of the lens is always clear. Clean dirt or water drops with soft cloth in order to
avoid the picture blooming or reflection.
6-2. When using an auto iris lens (DC-drive)
1. Please take off the sleeve outer cable of the lens by 10mm
2. Please take off the sleeve inner cable of the lens by 2mm.
3. Solder the wires on the pin-connector (iris-jack) supplied with the lens according to the pin configuration as
shown in the drawing.
4. Assemble the lens.
5. Connect the Auto Iris jack.
6. Adjust the DIP S/W to DC according to the type of lens.
6-3. When using a C-mount Lens
● Please assemble C-Mount adaptor.
● C-Mount adaptor is included in the package.
● Fix the lens by turning it clockwise.
6-4. When using a CS-mount Lens
Pin No.
Lens
DC
No.1 Pin
Damping -
No.1 Pin
Damping +
No.1 Pin
Drive +
No.1 Pin
Drive -