Installation guide

16 Series and 24 Series Engravers 13
© 2014 Vision Engraving & Routing Systems
6 16 Series and 25 Series Routers
6.1 High Frequency Router Head
High Frequency Router Head Wiring Connections
1. The controller Pendant is connected to the Pendant port on the controller.
2. The Ethernet Cable from your computer, hub or network is connected to the Ethernet port on the
controller
3. The Auxiliary Table Cable is used on the 25 Series machines ONLY. It connects the Serial Table
Connector on the machine to the Aux Table port on the controller.
4. The Table Cable connects from 25 Pin Table Connector on the machine to the Table Port on the
controller
5. The machine's Spindle Cable connects to the Spindle port on the controller.
6. The Power Cable connects a 110 - 220 VAC electrical source to the controller and powers the
controller and table.
7. The MOD/BUS Cable from the Inverter connects to the MOD/BUS port on the controller and controls
the High Frequency Router Motor.
Series 4 Controller (rear view) Router Head Connections
Pendant