Manualshelf

Installation guide

ManualsBrandsVision ManualsEngraverMaxPro
11121314151617181920
16 Series and 25 Series Routers 15
© 2014 Vision Engraving & Routing Systems
Carriage Wiring Connections
The Motor Plug connects to the Spindle Port on the back of the Carriage.
Carriage (rear view)
Mounting the Inverter on the 25 Series Table Stand
The Inverter is mounted on the top-left corner of the machine's stand. There are two flanges mounted on
the rear of the inverter. These flanges are placed in the inside of the stand's legs. Screws are included
with the inverter to secure the inverter to the stand. Instructions for assembly of the stand are included
with the stand, which is packed underneath the machine in its shipping crate.