Installation guide

Vision Engravers and Routers PRE-Installation Guide28

8.2 Wiring Connections

The Main Power Switch is located on the left side of the VR48.

The main power supply is connected to the Main Electrical Box on the left side of the VR48. Remove

the cover and make the connections as shown below. Ground is connected to the bare wire and

common leads are connected to the two shielded wires. The supply for this connection is Junction Box

#1 (220 VAC, Single Phase).

Note: The picture below is for illustration purposes only. The power cable should enter the Main

Electrical Box through the hole in the left side of the box as shown in the above picture.