Installation guide

VR48 Router 29

On the front of the control box for VR48 Router, there are four connection ports; One is an Ethernet

port used to connect your computer or network to the on-board Series 4 Controller, the second is for

the Pendant, the third is a USB port used to connect a computer to the VR48 when using the DACS

Camera System, and the fourth is to connect the Remote Start Switch for the Dust Collector System.

Plug the network cable (or the crossover cable) into the Ethernet port on the VR48, then either plug the

network cable into your network (or hub), or using the crossover cable, plug into the network port on

your computer. Plug the Pendant cable into the Pendant and Pendant Port on the VR48. Connections

for the DACS Camera System are detailed in a separate section of this manual. Connect the Dust

Collector Remote Start Cable to the Remote Start Port using the supplied cable.

NOTE: The crossover cable is colored white with green ends. The standard network cable is one solid

color.