Installation guide

Vision Engravers and Routers PRE-Installation Guide8

4 Phoenix 1212

Phoenix 1212 Engraver/Series 4 Controller Connections

There is only one connection port on the Phoenix 1212. It is a 25 pin Table Cable port on the left side

of the machine. All other connections on the machine's controller are listed below.

1. The engraver's Pendant is connected to the Pendant cable port.

2. The Ethernet Cable from your computer, hub or network is connected to the Ethernet port.

3. The Table Cable connects from 25 pin connector on the engraver to the Table port.

4. The Power Cable connects a 110 - 220 VAC electrical source to the controller and powers the

controller, table and spindle.

Note: If your machine is equipped with the optional Vacuum Chip Removal System, a remote On/Off

cable is connected to the controller to automatically turn the vacuum pump on and off when the job is

being run.