Specifications

22 Multi Axis Engraver Operating Manual
Next, loosen the tilt adjustment lock screw shown below in figure 3.18 screws approximately 1 turn.
(Figure 3.18) The tilt adjustment lock screw
You will now need to tilt the clamping assembly up or down to align the edge of the material you are engraving with the
spindle. See figure 3.19 below.
(Figure 3.19) Levelling the engraved object
Once the object is parallel to the spindle, tighten the tilt locking knob.
Next, adjust your spindle and cutter. For help with setting the spindle and cutter, please see the section on adjusting the
spindle later in this chapter.