Specifications

TC2-CTL3_manual_en

NOTE: When you press ‘learn’ in software wait until the red LED appears on the module,

then point original remote at front of module and press and hold button.

6. SCHEDULE LAST If using the scheduling function, do this once all of the codes have been

learnt.

IMPORTANT:

The software contains a pre-set library of RS-232 codes. When you add new codes and sync

and software, those new codes become available to all users when they sync and can be edited.

If an extension keypad is used all code will be saved on the master device. The slave device is

connected to the master via the RS485 terminal.

TROUBLESHOOTING

If your system is not operating properly, please refer to the following information. If the

problem persists, disconnect from power and contact your AV reseller immediately.

Problem

Correction

No LED when buttons pressed

• If powered by batteries make sure switch under

batteries set to BATT or PWR as appropriate

• Replace batteries. Voltage must be higher than

2.8V

• Check mains power connection (if using).

• If using mains power remove batteries

• Make sure codes have been learnt

Module fails to learn the code

• Make sure the original remote is 50mm away from

the IR receiver on the top/front of the module, and

at 90 degrees

• Make sure the original remote has fresh batteries.

• Hold down the button on the original remote for

longer and release only after the green LED lights

on the module