User`s manual

Acquisition Control AW00049313000
130 Basler runner
could increase the packet size or decrease the inter-packet delay. If you are using several
cameras connected to the host PC via a network switch, you could also use a multiport
network adapter in the PC instead of a switch. This would allow you to increase the Ethernet
bandwidth assigned to the camera and thus decrease the transmission time.
For more information on the settings that determine the bandwidth assigned to the camera, see
Section 5.2 on page 33.
Example
Assume that you are using an ruL2098-10gc camera set for an exposure time of 190 µs and a frame
height of 500 lines. Also assume that you have checked the value of the Device Current Throughput
parameter and the Payload Size parameters and found them to be 110000000 and 5120000
respectively.
Factor 1 (sensor readout):
Max Lines/s = 9200
Factor 2 (exposure time):
Max Lines/s = 5223 Lines/s
Factor 3 (frame transmission time):
Max Lines/s = 10742
Factor 2, the exposure time, is the most restrictive factor. In this case, the exposure time setting is
limiting the maximum allowed line rate to 5223 lines per second. If you wanted to operate the
camera at a higher line rate, you would need to lower the exposure time.
Max Lines/s
1
190 µs 1.44 µs+
--------------------------------------------=
Max Lines/s
110000000
5120000
------------------------------


500=