User`s manual

Revision History AW00049313000
232 Basler runner
AW00049310000 8 June 2010 Expanded and modified the sections added in the previous release.
Added a note regarding focal flange distances to Figure 3 in Section 1.4.1
on page 7.
Added a note about maximum Height parameter values in Section 8.1.1 on
page 71 and Section 8.2.1 on page 77.
Added the frame timeout and the frame timeout event in Section 8.2.3.4 on
page 86 and Section 11.4 on page 186.
Updated the delay values for the ruL2098-10gc in Section 8.2.4.2 on
page 88.
Modified the use case diagrams (introducing "waiting for a trigger" states),
added new diagrams, and added descriptions in Section 8.2.6 on page 96.
Updated the C
1
value for the ruL2098-10gc and the calculated example in
Section 8.7 on page 128.
Added the frame counter reset in Section 12.3 on page 212.
Added statements about availabilities of the frame trigger counter and the
frames per trigger counter and the relevance to partial frames in
Section 12.5 on page 217.
Added the encoder counter chunk in Section 12.6 on page 220.
Added the input line status at line trigger chunk in Section 12.7 on
page 222.
AW00049311000 5 Jan 2011 Added information about the relation between packet timeout and inter-
packet delay in Section 4.1 on page 20, Section 4.2 on page 21 and
Section 5.1 on page 31.
Added information about the payload and non-payload portion of the packet
size in Section 5.1 on page 31.
Added a table detailing voltage levels for I/O input when using LVTTL in
Section 7.7.1.1 on page 54.
Added the acquisition start trigger to the list of functions for which an input
line can be selected in Section 7.7.1.3 on page 59.
Indicated that the maximum possible frame rate can not be achieved with
the acquisition mode parameter set to single frame in Section 8.2.1 on
page 77 and Section 8.7 on page 128.
Added the acquisition trigger wait signal to Section 7.7.2.4 on page 65 and
Section 8.5.3 on page 126.
Added the acquisition status feature in Section 8.5.2 on page 125.
Added event parameter names and the acquisition start overtrigger event in
Section 11.4 on page 186 and removed some descriptions for transfer to
the "Camera Events" code sample of the pylon SDK.
Removed the feedback section.
AW00049312000 19 May 2011 Indicated tolerances as typical in Figure 4 in Section 1.4.2 on page 8.
Indicated the applicability of the pinout diagram in Figure 20 in Section 7.7
on page 53.
Modified and expanded the description of the RS-422 interface circuit in
Section 7.7.1.1 on page 54 and Section 7.7.2.1 on page 61.
Doc. ID Number Date Changes