User`s manual

AW00049313000 Physical Interface
Basler runner 43
7 Physical Interface
This chapter provides detailed information, such as pinouts and voltage requirements, for the
physical interface on the camera. This information will be especially useful during your initial
design-in process.
7.1 General Description of the Connections
The camera is interfaced to external circuity via connectors located on the back of the housing:
 An 8-pin RJ-45 jack used to provide a 100/1000 Mbit/s Ethernet connection to the camera.
This jack includes a green LED and a yellow LED that indicate the state of the network
connection.
 A 6-pin receptacle used to provide power to the camera.
 A 12-pin receptacle used to provide access to the camera’s I/O lines.
The drawing below shows the location of the three connectors and the LEDs.
Fig. 16: Camera Connectors and LEDs
8-pin
RJ-45
Jack
(Ethernet)
6-pin
Receptacle
(Power)
Green LED
Yellow LED
12-pin
Receptacle
(I/O)