User`s manual

Acquisition Control AW00049313000
84 Basler runner
To see graphical representations of frame start triggering, refer to the use case diagrams in
Section 8.2.6 on page 96.
Note
By default, Input Line 3 is selected as the source signal for the Frame Start
Trigger.
If the Frame Start Trigger Source parameter is set to Shaft Encoder Module
Out, the recommended setting for the Frame Start Trigger Activation parameter
is Rising Edge.
If the Frame Start Trigger Source parameter is set to Line 1, Line 2, or Line 3,
the electrical signal applied to the selected input line must be held high for at
least 100 ns for the camera to detect a transition from low to high and must be
held low for at least 100 ns for the camera to detect a transition from high to low.