Specifications

6
TC2-AMP4_manual_en
NOTE 2: THIS IS A LOW-IMPEDANCE AMPLIFIER. DO NOT ATTEMPT TO CONNECT 100V
LINE SPEAKERS (Normally any speakers with “t” in the part code)
Alternative Configuration
PROGRAMMING MEMORY
The Techconnect Amplifier turns on automatically when mains power turned on.
The amplifier has an adjustable memory:
Mode 1: Assumes a pre-set input and volume
Mode 2: (default) Resumes last input and volume
TO VIEW CURRENT MODE AND SWITCH MODE:
1. Turn amplifier off
2. Hold down volume+ then power buttons for 5 seconds. Input indicator will flash 8 times
showing current mode.
3. To change mode repeat step 2. Input indicator will flash 8 times showing the other mode.
4. Turn mains power off to apply change to memory.
TO ADJUST SETTINGS FOR MODE 1:
1. Check it is in mode 1. Set volume and input
2. Turn amplifier to off (standby)
3. Hold down volume+ then volume- for 5 seconds. Input indicator will flash 8 times
indicating the new setting has been saved.