TECHCONNECT HDBT OWNERS MANUAL www.visionaudiovisual.
DECLARATION OF CONFORMITY Where applicable Vision products are certified and comply with all known local regulations to a „CB Certification‟ standard. Vision commits to ensure all products are fully compliant with all applicable certification standards for sale in the EU and other participating countries. The product described in this owner manual is in compliance with RoHS (EU directive 2002/95/EC), and WEEE (EU directive 2002/96/EC) standards.
USE ONLY DOMESTIC AC OUTLETS Connecting the unit to an outlet supplying a higher voltage may create a fire hazard. HANDLE THE POWER CORD WITH CARE Do not disconnect the plug from the AC outlet by pulling the cord; always pull the plug itself. Pulling the cord may damage it. If you do not intend to use your unit for any considerable length of time, unplug the unit. Do not place furniture or other heavy objects on the cord, and try to avoid dropping heavy objects on it. Do not tie a knot in the power cord.
OVERVIEW This product sends uncompressed HDMI over CAT6 (ethernet) cables. The cable can be up to 70m long. Vision‟s HDBaseT products will work with other HDBaseT approved by the HDBaseT Alliance. HDBaseT signal cannot be routed through a TCP/IP network. This product simply passes the EDID information through and cannot change it. TRANSMITTER 1 1. 2. 3. 2 3 12V 2A Power input RJ45 (CAT6) Output HDMI Input RECEIVER 1 1. 2. 3.
INDICATOR LIGHTS 4 4. 5. 6. 7. 5 6 7 Power LED Status LED – indicates transmitter and receiver are connected to each other Link LED – indicates HDMI input is connected HDCP LED – indicates signal is encrypted (flashing means not encrypted) INSTALLATION 1. CONNECT CABLES You can use unshielded or shielded twisted pair. It is technically possible to use either CAT5e or CAT6 cable. CAT6 is superior quality and has a lower skew rate.
TROUBLESHOOTING If your system is not operating properly, please refer to the following information. If the problem persists, disconnect from power and contact your AV reseller immediately. Problem Correction Status lights no on Check CAT5e/6 cable The cable should be wired to 568B standard at both ends. If one end has green and orange swapped this is a crossover cable and cannot be used.
SPECIFICATIONS TRANSMITTER/RECEIVER DIMENSIONS: 106 x 74 x 15 mm PRODUCT WEIGHT: 0.36 kg (per set) CONSTRUCTION MATERIAL: Metal COLOUR: White TECHNICAL DETAILS: Signaling rates: 2.97Gbits x 3 Input Video Signal: 0.5-1.
WARRANTY This product comes with a 2-year return to base warranty, effective from the date of purchase. This warranty applies only to the original purchaser and is not transferable. For the avoidance of doubt, this will be taken from the information held by the appointed national distributor at the point of sale. If the product is DOA (dead on arrival), you have 21 days from purchase date to notify the national distributor via your AV reseller.
