Specifications

2322
Chapter 7 Charging & uSing the Battery
Chapter 8 tipS For uSing the uSB Bridge
Figure1
Figure2
Figure3
Charging the battery:
1) Insert the lithium battery into
the charger base of the USB
Bridge so that it can fully
charge. Do not use extreme
force when inserting the bat-
tery, as it will only t securely
in one direction (SeeFigure
1).
2) Connect the tip of the
included power supply to the
“DC 12V” input port on the
rear of the USB Bridge
(SeeFigure2).
3) Plug in the remaining end
of the power supply to an
available AC/mains outlet.
(SeeFigure3).
4) Press the POWER button
on the front of the USB
Bridge. When the battery is
charging, the red “CHARGE”
indicator illuminate.
(SeeFigure4).
5) When the “CHARGE” indicator begins to blink,
the battery has fully charged. Resume normal
USB Bridge operation as described on page 14.
Figure 4
General Tips
• Use caution when attaching the output of your
Enhanced Vision product to the CAMERA input
of the USB Bridge. The specially designed
connector will only t in one direction. Once
attached, it should not be removed under normal
circumstances.
• Do not disconnect the USB cable from your PC or
the USB Bridge while the software application is
running. This may cause your system to become
unstable. Always exit the software application
before disconnecting the USB cable.
Using Acrobat NTSC/PAL
with the USB Bridge
• The Acrobat (long or
short arm version) is
compatible with the USB
Bridge.
• Using a new, fully charged lithium battery, the USB
Bridge will supply portable power to your Acrobat
NTSC/PAL for approximately 2 hours*
• Be sure to use the Acrobat with sufcient ambient
lighting. Because this device projects a magnied,
camera-based image, adequate lighting will
ensure that the best picture quality is obtained.
*Estimatedtimesonly.Actualusagetimeswillvary
based on the life cycle remaining on the battery.
TIPS FOR USING THE USB BRIDGE