Specifications

1110
Chapter 4 paCkage ContentS & ControlS
Chapter 5 inStallation
Figure1
SOFTWARE INSTALLATION
2 3
4
5
11
12
10
1
6
7
8
9
1. Start up your PC as normal.
Load the included CD-ROM
containing the Viewer Applica-
tion software and USB drivers
into the CD-ROM drive of your
PC (SeeFigure1).
IMPORTANT! It is highly recommended that you
install the included software before making the
hardware connections to your PC.
Do not connect the included USB cable or the
hardware interface to your PC until after the
software installation has completed. Failure to follow
these instructions may cause your PC to “freeze” or
cause the USB Bridge and software to incorrectly
function. Should you need assistance installing the
included software, please seek the assistance of a
trained computer specialist or contact our technical
support department.
[phone] (US Ofce, toll-free)
[phone] (outside the US)
[e-mail]
NOTE:Installingthesoftwaremayrequirethatyou
haveadministratorprivilegesonyourPC.
Use the following procedure to install the software for
the USB Bridge: