User's Manual

2015-07-31

V029627_02_WOFS_Installation_Guide.docx Page 12 of 20

9 Installing or Changing Transmitter Batteries

Before mounting the Transmitter to a wall or secured surface, install 2 AA-sized alkaline

batteries using the steps below:

1. Remove the 4 recessed, Phillips-head screws and open the Transmitter case to access the

battery compartment (see Figure 13).

o Remove the old batteries, if applicable.

2. Insert 2 AA-sized alkaline batteries matching the polarity pictured in the battery holder (see

Figure 14).

3. Reassemble the case and reattach the Phillips-head screws.

NOTE: The Transmitter is equipped with a Tamper Identification Device (TID) which will send

an alarm when the Transmitter box is opened or removed from the secured surface (see Figure

15). If the user is changing batteries, the user should notify the Monitor Station(s) that changing

batteries will trigger an alarm.

Figure 14 - Transmitter's Tamper Identification Device (TID)

Figure

serting or removing

batteries: Push the battery into the

battery bracket

Figure

Removing the four screws to

open the case