User's Manual

2015-07-31
V029627_02_WOFS_Installation_Guide.docx Page 8 of 20
o Use the terminal jacks that are either Normally Open (N/O) or Normally Closed
(N/C), depending on the configuration of the alarm panel (see section 7 of this
manual for more information on the N/O or N/C requirements).
2. Route the wires from the Receiver terminal block through the hole next to the SMA antenna
connector (see previous Figure 8).
8. Use the zip tie to secure the wires in order to reduce the strain on the terminal block wires
(see previous Figure 8).
9. Reassemble the WOFS Receiver case, and then reattach the Phillips-head screws.
10. Turn on the +12VDC supply to the Receiver.
6 Receiver Antenna
The Receiver has a female SMA connector at the top of the case to connect the 2.4 GHz antenna,
which communicates with the Transmitters. Attach the Receiver Antenna to the Receiver by
placing the antenna carefully on the SMA connector (see previous Figure 8), lining up the center
pin, and turn the antenna clockwise until the antenna is securely attached to the Receiver.
NOTE: The iRMS unit has an antenna external to the iRMS case and can receive transmissions
for the Receiver, or from the Transmitters, using its own iRMS antenna.