User`s manual

User’s Manual
24
receiver.
Position Set: For detailed operations, please refer to 8.2 DiSEqC1.2.
TP Setup: Press
keys to select a transponder (TP). You can also press OK key to
display TP edit window. For more details, please refer to 8.4 Transponder (TP) Edit.
4. Press EXIT key to save and exit.
8.2 DiSEqC1.2
Note: The settings of motor control should be operate
wise the satellite dish may not work properly.
These settings are for motor control of satellite dish.
Select Main Menu → Installation → Installation and press
1. Press
d by qualified personnel, other-
OK key to enter.
keys to select a satellite in satellite list.
2. Press
key to move cursor to parameter list.
3. Highlight “Position Set” and press
keys to select
enter. Set it to “OFF” if you have no positioner equipment.
4. Set parameters as follows:
Current Position: Display current position of motor.
Movement: Press
“DiSEqC1.2” and press OK key to
keys to move dish westward or eastward, motor will stop auto-
matically according to signal strength and quality.
Nudge: Press
keys to nudge dish westward
or eastward until turn it to a proper position.
Recalculation: Recalculate other satellite posi-
tions according to current satellite position. Press
OK key and a message box pops up for confirma-
tion. Select “OK” and press OK key to confirm or
select “EXIT” and press OK key to cancel the op-
eration.
East/West Limit: Set east and west limits of mo
Press OK key to display east/west limit window.
confirm or select “EXIT” and press OK key to cancel the operation.
Limit Disable: You can disable east and west lim-
its of motor. Press OK key to display limit disable
window. Then select “OK” and press OK key to
confirm or select “EXIT” and press OK key to
cancel the operation.
Go to Reference: Restore satellite dish to zero
point position. Press OK key and a message box
pops up for confirmation. Select “OK” and press
OK key to confirm or select “EXIT” and press OK
key to cancel the operation.
5. Press EXIT key to save and exit.
8.3 Rename Satellite
Select Main Menu → Installation → Installation and press OK key to enter.
1. Press
tor to reduce possible dish path block.
Then select “OK” and press OK key to
keys to select a satellite.
2. Press Blue key to pop up a keyboard.
3. Input the name of satellite. Please refer to following operations: