Manual

INSTALLATION
19
• If you choose not to accept the license agreement, click Cancel. Click Close on the Installation
Interrupted window.
4. The software will now be installed.
5. Stop when you see the “Complete the installation by connecting your hardware” window. Do not click OK
yet. Leave the window open and proceed to the next section.
N
OTE: If you do not see this on-screen diagram for connecting the scanner, stop and follow the instructions below.
CONNECT THE USB CABLE
The scanner does not have an external power supply. It draws its power directly from the computer through the
USB cable. If you use a USB hub with your computer, the hub must have its own power supply. The scanner does
not have an on/off switch. The scanner is ready to scan as soon as its software is finished loading onto your
computer.
1. Remove any tape from the USB cable.
2. Plug the USB cable into the USB port on the scanner then into a USB port on the computer.