User Manual

MAINTENANCE VISIONEER
®
ROADWARRIOR 4D
S
CANNER USER’S GUIDE 35
Caution: use care when cleaning the scanner to avoid damaging the sensors. The paper sensor and
scanner cover sensor are plastic levers inside the scanner. They are fragile and can break.
The paper sensor lever runs along the front of the scanner. If the paper sensor becomes damaged, the scanner
will no longer detect when paper has been inserted into the scanner. The cover sensor is located on the left end of
the feed roller. If the cover sensor becomes damaged, the scanner will no longer detect when the cover is closed.
1. Place your thumbs on either side of the paper feed slot, underneath the lid of the scanner. Hold the scanner
sides firmly and pull the scanner lid up to release it from the body of the scanner.
Use both hands to open the scanner, the lid is held down with locking arms on both sides of the paper feed
slot. If you open only one side, you may damage the scanner lid.
2. Using the cleaning cloth, wipe down all surfaces in the scanner. Make sure to clean the glass in the underside
of the scanner lid and the feed rollers in the body of the scanner.
Paper sensor lever
Cover sensor lever