User Guide

Clamp Function: When The Transmitter (remote) button is pressed once the receiver
turns ON and stays ON. The receiver will remain on regardless if another remote is pres
sed. To turn OFF the receiver Press the Receiver function mode button once and the
device will reset.
Press on Function: As long as the Transmitter (remote) Button is pressed, the receiver will
stay on.
1 second delay Function: When the Transmitter (remote) button is pressed, the receiver
will turn on for 1 second and automatically turn off after the 1 second.
SELECTING THE DIFFERENT
FUNCTION ON THE RECEIVER
The Function button can be found by looking at the diagram below:
4-second Delay Function (this is the Default)
1 Flash
Press down on the channel Function Button for 3 or more seconds. The channel’s LED
light will flash a number of times equal to the output it is in.
In order to Change the channels function on the receiver, press the channels function
Switch. Each press moves the receiver to the next function.
After setting the function of choice, verify the number of flashes in order to make sure
that the proper function has been selected.
Wait for 15 seconds so the receiver can exit the function Programming.
Press on Function
4 Flashes
ON/ Off Toggle Function
2 Flashes
Clamp Function
3 Flashes
1 Second Delay Function
5 Flashes
LED INDICATION
Steady ON: Receiving signal from the
Transmitter (remote). This verifies
that that the Transmitters (remotes)
code is programmed in the receiver's
memory during programming of the
Transmitter (remote).
Fast Flash: This verifies that the recei-
ver is in programming mode for the
Transmitter (remote).
One Flash: A transmitter (remote) was
programmed.
Two Flashes: All Previously Program-
med Transmitter (remote) were dele-
ted.
Receiver
Relay
-
+
NC
COM
NO
LED
Indicator
Function
Switch
Programming
Switch