User guide

2 & 4 DRIVE USER GUIDE
Page 26 of 57
Storage Screens
The Storage screens provide all the necessary options required for individual storage disk configuration and
maintenance. You can also change RAID configuration, set shared folder names, format and disconnect USB
hard drives that are connected to the system.
The above screen shows a screen shot from the SCM200, which has two drives. The SCM400 screens will
actually show up to four drives, and different RAID configurations. Beyond these two things, the screens will be
very similar.
Disk Management Screen
The Disk Management screen provides a detailed summary of the hard drives, installed on SCM200/SCM400.
Again, on a SCM400, you will see up to four drives listed, unlike the two drives on the SCM200.
The drive status allows you to monitor hard drive fault conditions and activity.
Good - Indicates the hard drive is accessible and functioning normally.
Failed - Indicates a fatal error has occurred, such as the hard drive partition has been deleted, corrupted, or
damaged, which could result in data loss.
Foreign - Indicates SCM200/SCM400 has detected an old hard drive or a hard drive containing other data has
been installed. A Clean disk icon appears on disks that display the “Foreign” status. Unless the user
performs a clean disk operation, the hard drive cannot be accessed. After performing a clean disk operation, the
hard drive appears on the Disk Management table.