Instructions / Assembly

9
MILANO 100 INSTALLATION INSTRUCTIONS PAGE 12
SURFACE INSTALLATION
C
I
I
I
B
M
M
M
D
M
M
ADJUSTING THE HANDLES
Adjust the G-Handle heights by loosening the Allen-Head Set Screw, move the
G-Handle as desired and retighten screw.
10
K
K
G
SECURE THE RAILS WITH SCREWS
C-Top Guide Rail Using the Decorative Trim Groove [7.2] as a guide, staying
above the glide platforms inside the Top Guide Rail, drill 1/8” (3mm) holes at a
location 4” in from each end and through both sides of the Top Guide Rail. Drill
2 holes for single screens. Secure the Top Guide Rail to the entry with M-1/8”
(3mm) x 1-3/4” (44mm) Surface Mount Screws. Do not overtighten.
B-Bottom Guide Rail Using the Decorative Trim Groove [7.2] as a guide
(staying underneath the glide platforms inside the Bottom Guide Rail), drill
1/8”(3mm) holes evenly spaced through both sides of the Bottom Guide Rail.
Drill 3 holes for single screens. Secure the rail to the entry with M-1/8”(3mm) x
1-3/4”(44mm) Surface Mount Screws. Do not over tighten. If the B-Bottom
Guide Rail will be positioned where it is susceptible to being stepped upon,
kicked or otherwise bent, then add structural support for the B-Bottom Guide
Rail to rest upon. A 1/2” x 1/2” “L” shaped aluminum extrusion is recommend-
ed. This or another support material may be purchased at a local hardware store.
Pile Opener