Instructions / Assembly

THE SCREEN CASSETTE

The A-Screen Cassette Assembly can be installed on either the right or left

side of the door jamb. The Screen Cassette comes from the factory for

right-handed installation. For a left-handed install, ﬂip the Screen Cassette

vertically, remove and discard the right-oriented Pull Bar End Caps and replace

with the left-oriented Pull Bar End Caps [3.1] from the Screen Accessory Kit.

Remember, for either orientation, the TALLER Pull Bar End Cap must always

be at the top, the SMALLER L-Pull Bar End Cap must always be at the bottom,

and the rounded side of the Cassette should always face outwards.

3.1

MILANO 100 INSTALLATION INSTRUCTIONS PAGE 4

RECESS INSTALLATION

INSTALLING THE CASSETTE

Using the I-#8 x 1”(25mm) Phillips Panhead Screws, install the H-Recess

Mounting Clips 16” from the top and bottom of the door opening [4.1].

Lock the Screen Cassette onto the mounting clips [4.2].

For a left-handed

install, flip the Screen

Cassette and replace

the End Caps with

the left-oriented End

Caps from the Screen

Accessory Kit.

Tall Pull Bar End Cap at Top

Small Pull Bar End Cap at Bottom

4.1 H-Clips for Recess Install

4.2 Recess Installation

Insert into clip

ﬂange here.

Snap into clip

notch here.

VIEW FROM

ABOVE

Cassette

CRIMP WEATHER STRIPS

Crimp in the upraised channel lip on the inside of each corner of the C-Top

Guide Rail to keep the J-Pile/Weather Strip from moving, as shown at left.