Instructions / Assembly

THE SCREEN CASSETTE
The A-Screen Cassette Assembly can be installed on either the right or left
side of the door jamb. The Screen Cassette comes from the factory for
right-handed installation. For a left-handed install, flip the Screen Cassette
vertically, remove and discard the right-oriented Pull Bar End Caps and replace
with the left-oriented Pull Bar End Caps [3.1] from the Screen Accessory Kit.
Remember, for either orientation, the TALLER Pull Bar End Cap must always
be at the top, the SMALLER L-Pull Bar End Cap must always be at the bottom,
and the rounded side of the Cassette should always face outwards.
3
MILANO 100 INSTALLATION INSTRUCTIONS PAGE 9
SURFACE INSTALLATION
A
L
M
L
M
INSTALLING THE CASSETTE
Remove and discard the P-Pile/Weather Strip from the back of A-Screen
Cassette. Slide two L-Surface Mount Clips into the groove on the rear of the
Screen Cassette before proceeding [4.1]. Position the Screen Cassette, and
use I - #8 x 1"(25mm) Phillips Panhead Screws to secure L-Surface
Mount Clips to the opening [4.2].
4
4.1 L-Clips for Surface Install
4.2 Surface Installation
3.1
For a left-handed
install, flip the Screen
Cassette and replace
the End Caps with
the left-oriented End
Caps from the Screen
Accessory Kit.
Tall Pull Bar End Cap at Top
Small Pull Bar End Cap at Bottom